Frequently Asked Questions
Q- Are we able to alter configuration of the cabinets from the picture?
A- Yes, however be aware that depending on the configuration that you would like to complete you may need to purchase extra brackets to support the work top.
Q- The tool drawer is locked and the key is inside?
A- The lock can be disengaged by turning the cabinet upside down, however if the tool drawer does not disengage please contact customer support.
Q- The cabinets are stuck inside the locker, how do I get them out?
A- You can easily remove the doors by following step by step instructions that are located in the manual.
Q- What can I clean the Stainless Steel with?
A- To clean the cabinets you can use a soft cloth with soap and water.
Q- Are the doors adjustable?
A- The Performance Plus has a 6 way adjustable European hinge. All other cabinets (Pro, Bold, Performance Series) do not have adjustable hinges.
Q- Can I purchase more locker shelves?
Q- Can we purchase additional shelves for the wall cabinets/ base cabinets?
A- Wall cabinet shelves can be purchased on www.shopnewage.com/ca
B- Base cabinet shelves are not available for purchase at this time.
Versarac Ceiling Racks
Q- Can the 4’ x 8’ Versarac be adjusted in size to a 4’ x 4’?
A- The Versarac can be adjusted to only 4×6 and 4×8. This cannot be staggered.
Q- Can I install this product parallel to the beam?
A- Our recommendation is to contact a local contractor.
Q- What are the adjustment sizes?
A- The heights are as follows: 1 inch – 18 inch or 27 inch to 42 inch.
Q- The instructions show 3 holes in the ceiling mount but they have 4 holes?
A- You are able to mount the upright vertical post as long as it is the middle of the bolts.
Q- What sizes do the rolls come in?
Q- Does this product stain?
A- The Roll Floor is NOT stain-proof. If chemical spills, rubber tire marks, rust marks or other fluids are left on the floor for a prolonged period of time, they may cause permanent stains. Do NOT use harsh chemicals to clean the floor, this may cause discoloration.
Q- Can I put the product side by side?
Q- When I received the floor and tried to lay it flat the edges roll up?
A- Unpack and install product as soon as possible after you’ve received it. The roll is wound tightly during transportation and it will unroll and flatten easier if it is unrolled out of its packaging immediately after purchase. Initially, the roll floor will have small bubbles, ripples or curl marks in the floor. In colder climates, it may take 2-4 days for most curls or ripples in the floor to flatten out. To make the roll floor lay flat, use a large push broom to flatten out air trapped under the roll. Start pushing at the center of the roll and work your way out to the ends for best results. These curls and bumps are normal, as the floor was wound tightly during shipping, and will need a few days to relax and conform to your floor. If you need to park on the floor immediately, you can do so after unrolling the floor, and do not have to wait until all of the curls or ripples have flattened out.
Q- Can the floor be glued down?
A- The roll floor may be glued down, however this will void your warranty as NewAge Products does not recommend it.
Q- Can I use this product outside?
A- Versaroll is designed for indoor use only.
Q- Am I able to substitute cabinets?
A- They do come as a bundle package and are not able to be substituted. You may purchase additional cabinets from certain online retailers.
Q- My lock on the cabinet is too short?
A- A shelf needs to be placed centrally in the cabinet so when the lock is engaged, the latch hooks to the bottom lip of the shelf.
Q- I have lost my key for the tool cabinet or it is locked and cannot open it?
A- Please call our customer service team and they will send a replacement key for the unit. Replacement Form
Q- Is it possible to have all the locks the same?
A- The tool base lock has a different key mechanism than the other units, the key will always be different than the other cabinets.
Q- Upon delivery I am missing cabinets?
A- There are two answers for this, 1) the cabinets are nested inside the locker for shipping, 2) the cabinets may be shipping from two locations.
Q- The doors/drawers do not close properly?
A- The cabinets must be leveled and squared, please ensure this by adjusted the levels on the feet and adjust the hinges if possible.